تقويت فشاري ستون با استفاده از كامپوزيت FRP با الياف قائم و روش شيارزني

چكيده انگليسي :

Compressive Strengthening of Columns Using FRP Composites with Vertical Fibers and Grooving Method Niloufar Moshiri n moshiri@cv iut ac ir January 16 2013 Department of Civil Engineering Isfahan University of Technology Isfahan 84156 83111 Iran Degree M Sc Language Persian Supervisor Dr Davood Mostofinejad Prof Email address dmostofi@cc iut ac ir Abstract FRP composites have been widely used in retrofitting of reinforced concrete structures Columns of a building play an important role in performance of the structure and its safety Srengthening of columns by means of FRP composite and developing new methods in order to provide safe designs is therefore essential Srengthening of RC columns is possible by means of FRP composite jackets around the column The jackets are used mainly in a way that all or most of the fibers of composite are perpendicular to the column axis and in hoop direction to provide confinement However the axial compressive strength of columns can be increased by using FRP composite with longitudinal fibers where the fiber sheets contribute by resisting compression directly Buckling of FRP composite causes inappropriate performance of composite under compressive stresses In longitudinally strengthened columns with FRP buckling of composite causes debonding of FRP from concrete surface On the other hand researches have shown that the newly developed grooving method method as alternative to surface preparation can postpone or in some cases eliminate debonding of FRP sheet from the surface of the strengthened beams Accordingly in this study the grooving method was utilized for installing the FRP sheet with longitudinal fibers along reinforced concrete columns and its influence on postponing the buckling and debonding of FRP was investigated In addition the compressive stresses of fibers in composite at maximum load were determined and compared with its tensile strength To perform the study 29 reinforced concrete columns with 500 mm height were tested experimentally under uniaxial compression 24 columns had circular sections of 150 mm diameter and 5 columns had 133 133 square section Experimental results showed that using the grooving method by externally bonded reinforcement on grooves EBROG technique increases the load carrying capacity of circular strengthened column with longitudinal composite by 14 However using conventional externally bonded reinforcing EBR method did not increase the ultimate load capacity of the strengthened columns significantly Furthermore the compressive stresses of fibers in composite increased significantly by using the grooving method and it reached to 50 percent of tensile strength of fibers in flat coupon tests Besides considering the fact that tensile strength of fibers in real specimens is much lower than the strength of fibers in flat coupon tests it was concluded that the fibers in composite achieve considerable compressive stresses It was shown in this research that in circular columns strengthened with vertical fibers using EBROG method compressive stresses up to 80 percent of tensile strength of fibers in real FRP strengthened specimens is accessible Key Words Circular RC column load carrying capacity compressive FRP composite buckling grooving method square column

مشيري، نيلوفر

تقويت فشاري ستون با استفاده از كامپوزيت FRP با الياف قائم و روش شيارزني

ستون بتن آرمه دايروي , ظرفيت باربري , كامپوزيت FRP تحت فشار , كمانش , ستون مربعي